User manual
64
With NiCd or NiMH batteries, you can switch between manual (Mn*) and automatic (AT*)
mode by simultaneously pressing the buttons „INC“ and „DEC“ (see chapter 12. a).
With lithium batteries, the cell number must also be set besides the charge current.
10. Change this as usual using the buttons “INC” and “DEC”, conrm the value using the “Start/
Enter” button.
11. If the values do not blink, you can select between the individual programs with the buttons “INC”
or “DEC”. Depending on the battery type, these are “CHARGE”, “DISCHARGE”, “STORAGE”,
“BALANCE”, “CYCLE”, etc.
12. If you now keep the button “Start/Enter” depressed for approx. 3 seconds, all settings are saved
in the memory selected at the beginning.
Of course, the data in the 5 memory slots is preserved, even if the charger is separated
from the supply voltage.
This way, you can save the data for the transmitter battery, for example (e.g. NiMH,
charge current 400mA) and for a ight battery (LiPo, 1A charge current, 3 cells).
16. LOADING BATTERY DATA
1. In the main menu, select the function “LOAD DATA” with the button “Batt Type/Stop”.
PROGRAM SELECT
LOAD DATA
2. Press the button “Start/Enter”; the display shows the following, for example, and memory “01”
blinks:
LOAD [01] LiPo
3.7V 2000mAh
3. With the buttons “INC” or “DEC”, select the desired memory (1....5).
4. Keep the button “Start/Enter” depressed for approx. 3 seconds. The display briey shows
“LOAD...”.
5. The data is applied and all settings are performed in accordance with the saved values.