User manual

65
17. WARNING MESSAGES ON THE DISPLAY
REVERSE POLARITY
The polarity of the battery poles has been reversed.
CONNECTION BREAK
The connection to the battery has been broken, e.g. if the
battery has been disconnected during the charging process.
SHORT ERR
A short-circuit has been established on the charger output.
PLS. RESTART
The input voltage (operating voltage) for the charger is too
low.
VOL SELECT ERR
The voltage of the LiPo, LiIon, LiFe battery to be charged is
incorrectly congured.
BREAK DOWN
The charger has established that there is an internal problem.
Should this message be displayed permanently, it is possible
that the charger is defective; have it checked by a specialist
workshop or qualied technician.
BATTERY CHECK
LOW VOLTAGE
The voltage is lower than which is set. Check if the voltage of
the battery has been correctly congured.
BATTERY CHECK
HIGH VOLTAGE
The voltage is higher than which is set. Check if the voltage of
the battery has been correctly congured.
BATTERY CHECK
CELL LOW VOL
The voltage in one of the cells of a LiPo, LiIon, LiFe battery is
too low. This can occur if a multicell battery has been charged
previously without a balancer.
BATTERY VOLTAGE
CELL HIGH VOL
The voltage in one of the cells of a LiPo, LiIon, LiFe battery is
too high. This can occur if a multicell battery has been charged
previously without a balancer.