User manual

C2 Button assignments

a) MAX MIN for the temperature measuring input "T1"

By actuating the button "MAX MIN" you get to the recording of the minimum and maxi-

mum values. The highest and lowest temperatures are constantly detected and recor-

ded. With each actuation of the button you can read alternately the maximum value

"MAX", the minimum value "MIN" or the current measuring value "MAX MIN" (flashing).

Actuate the button "MAX MIN" for approx. 2 seconds in order to quit the function.

Note!

It is not possible to change the measuring unit during the recording of the

maximum / minimum values.

b) CLOCK for the time display

The actual date with year (centre), month, day (at the bottom on the left) and time

(hours:minutes, at the bottom on the right) are indicated with the button "CLOCK"

(after setting the time). Each press of the button is confirmed with a short "Beep" of

the beeper.

In order to set the time, proceed as follows:

Actuate the button "T1 - T2" at the same time when you turn-on the thermometer in

order to set the time. In that way you will get to the setup menu "Set".

Now actuate the button "CLOCK" (= Hold). The display for the date and the time

appears, the year is flashing. With the buttons "^" for upwards (=" REC") and "v" (="°

C/° F") for downwards you can modify the setting upwards or downwards.

Set the year and actuate the button "CLOCK" once.

Now the segments for the month are flashing.

Set the actual month (e.g. 01 for January) and actuate the button "CLOCK" once

again. Now the segments for the day are flashing.

Set the actual day (e.g. 08 for the eighth day of the month) and actuate the button

"CLOCK" once. Now the segments for the hours are flashing.

Set the hours (24-hour display) of the actual time and actuate the button "CLOCK"

once. Now the segments for the minutes are flashing.

Set the minutes and actuate the button "CLOCK" once in order to finish the setting of the

time. The display indicates for a short time the available memory (e.g. 1 5984 for 15984

memory locations). Then the display changes to the "normal" temperature display.

Now the time is set relative exactly to the minute.

c) HOLD function

With each press of the button (brief) the HOLD function is activated or deactivated.

HOLD means that the current measuring value of T1 is held until the data hold func-

tion will be deactivated. While the measuring value of T1 stands still, the temperatu-

re difference T1- T2 and the temperature display T2 continue running. It is neither

possible to change from °C to °F or vice versa nor to activate the time display or the

function "MAX MIN".