User manual

Connection of the PC, installation of the

software

The communication between the thermometer and an IBM compatible PC can only

take place if the following requirements are met:

1. a connection between PC and thermometer and

2. the installation of the software

Concerning 1.

Connect the supplied interface circuit to the 9-pole sub D jack "COM 1" at the tur-

ned-off PC and then to the 3,5 mm stereo jack bush at the thermometer. Now check

the safe fit of the plug-in connection and turn-on both the thermometer and the PC.

Concerning 2.

There is a CD attached to the data logger digital thermometer 309. The software that

can be found on this CD now needs to be loaded on the PC. Put the CD into the rele-

vant CD-ROM drive of the PC and close the drive. Now the automatic setup starts.

Follow the instructions on the screen and finish the installation with a restart "Finish"

Click the Start button and then the field "Programs". Click the field "Windows-

Explorer" right at the bottom. Now click in the Windows-Explorer the field "D" or "E"

or "F" or something like that depending on the designation of your CD-ROM drive.

The contents of the CD are indicated. Double click the Icon "Setup".

Now the setup takes place. Follow the instructions on the screen:

First "Initializing" (basic elements) => window "ThermoLog" => "Welcome....." =>

"Components"- Selection => file designation in the start window => "Copying instal-

lation files" => "Reboot windows" with "finish".

After completed installation and restart, open the file "Programs" and click there

"Test Link" => "Se 309" and finally once again "Se 309".

Now the working window appears more or less quickly (depending on the working

storage and the speed of your computer). Further information will follow in the next

chapter.