User manual

Press button to switch to the area for setting the standby power.

c) Setting the standby power

1. Press SET button once. The power value starts ashing (g. 20 + 21).

2. This function is used to set the standby power value, which is useful for the total energy

calculation. Use or buttons to set the value and press SET to conrm. Set each digit

separately. The setting range is 0.001 - 9.999W.

3. After setting the normal standby power the display will switch to the area for setting the

low-energy standby power. The display will show indicating the low-energy standby power

(g. 22).

4. Perform the setting following the same procedure as for normal standby power and press SET to

conrm your setting. The setting range is 0.001 - 9.999W.

g. 20 g. 21

g. 22

Press button to switch to the area for setting the GHG/CO2 alarm limit.

d) Setting the rate of GHG/CO2

1. Press SET button once. The “GHG” (greenhouse gas) / “CO2” value starts ashing (g. 24).

2. Use or buttons to set the value and press SET to conrm. Set each digit separately.

g. 24g. 23

Press button to switch to the area for setting the OVERLOAD limit.