User manual
37
c) Setting the time
• As described in section b), hold the “SET” button (1) pressed for approx. 3 seconds to start
the set-up mode. “ ” will be shown in the top left of the display and “24R” (or “12HR”)
appears in the upper display for the currently set time display format.
The set-up mode can be closed early by pressing the “SET” button (1) again for approx.
3 seconds. The settings made are saved.
• Press the “SET” (1) button briey until “12” or “24” ashes in the display.
• Select the 12h or 24h mode for the time display using the “ ” (4) or “ ” (5) button.
If the 12h format is used, “PM” appears in the display on the right next to the time during the
second half of the day.
• Briey press the “SET” (1) button, the hours of the displayed time ash.
• Set the hours with the “ ” (4) or “ ” (5) button.
• Briey press the “SET” (1) button, the minutes of the displayed time ash.
• Set the minutes with the “ ” (4) or “ ” (5) button.
• Briey press the “SET” (1) button to conrm; the time display will stop ashing.
• When the time display no longer ashes, you can proceed to setting the electricity tariff (see
next section) by briey pressing the “ ” button (5). If you want to correct the time, briey
press the “SET” button (1) and proceed as described above.
If you want to close the set-up mode, hold the “SET” button (1) pressed for 3 seconds
(or do not press a button for one minute).
d) Setting the electricity tariff
•
If you have set the 12h/24h format and the time (see section c) before setting the electricity
tariff, you can proceed directly with the next step.
Otherwise, the set-up mode must be started by pressing the “SET” button (1) for approx.
3 seconds. “ ” will be shown in the top left of the display and “24Hr” (or “12Hr”) appears
in the upper display. By briey pressing the “ ” button (5) button
, you proceed to the set-up
for the rst electricity tariff, see next step.