Operation Manual

60
Dear customer, the following safety information is intended not only for the protection of
your health but also for the protection of the device. Please read the following items
carefully and observe them when using the charger and rechargeable batteries:
The unauthorized conversion and/or modification of the product is prohibited
for safety and approval reasons (CE).
The charger may only be connected to a stabilised direct current voltage of
11-18 V/DC.
Depending on the rechargeable battery connected and the charging pro-
gramme set, charging currents of up to 10A per charging channel are
possible. The charger’s power supply must be designed accordingly.
The product is intended for dry indoor use only. It must not get damp or wet.
Do not expose the device to direct sunlight, high temperatures (>35 °C) or
extreme cold (<0 °C). Keep it away from dust and dirt. The same applies to
any battery that may be connected.
The device is not a toy. It is not suitable for children. Pay particular attention
when children are present!
The product may only be set up, used or stored in places that are not acces-
sible to children. Children may change the settings or short-circuit the
battery,/battery pack which can lead to an explosion. Danger to life!
Do not use the battery charger inside a vehicle.
Do not place any containers filled with liquid, e.g. vases or plants, on or next
to the charger.
When these liquids get into the charger, the charger will be destroyed and
there is a considerable fire hazard.
If this occurs, immediately disconnect the product from the power supply,
then disconnect the battery from the charger. Do not use the charger again -
bring it to a specialist workshop.
Only operate the product in moderate climate, never in tropical climate. For
more information on acceptable environmental conditions, see the chapter
“Technical Data”.
Do not operate the product unattended. Despite a considerable number of
protective circuits, it is impossible to exclude the possibility of malfunctions
or problems during the charging process.