User manual
67
9. INITIAL OPERATION
a) Protective cap
The data logger is only dust tight and jet water protected with
attached protective cap (12) and rubber seals (9, 10). This
protection allows permanent logging operation in damp rooms
and outdoors.
• Only remove the protective cap for replacing the battery or reading the
data on the computer.
• Remove the protective cap by pulling it off from the data logger. The
protective cap ts tightly due to the rubber seal (10).
• Place the protective cap tightly back onto the data logger.
b) Connect to the computer
• Remove the protective cap (12) from the data logger.
• Connect the data logger to an available USB port of your computer.
• The computer recognizes the new hardware. The model type of your
data logger appears as a mass storage device on your computer.
c) Disconnect from the computer
• Eject the data logger from your computer and remove it.
• Place the protective cap back on the data logger.
d) Choose start/stop mode
• Choose start mode from “RECORD START CONDITION” during
conguration.
• Choose stop mode from “STOP STYLE” during conguration.