User manual
Voltsoft User Manual Version 2.4
43
6.2.4 DL121TH - Settings
Note: Any stored data will be permanently erased when setup is finished.
1
Time
Configure the device data time value.
The user can specify a defined time or use the system
date time.
2
Logger Name
Input the unique alias for that device.
3
Record Start Condition
By Button – The data logger will start recording only
after the user presses the red button on the device.
After Setup – The data logger will start recording
immediately after setup.
4
Sample Points
Instruct the logger to take a finite number of readings.
5
Sample Rate
Instruct the logger to log readings at a specific rate.
6
Recording Time
Calculate the recording time based on the selected
sample points and sample rate.
7
LED Flash Cycle
Configure the LED flash cycle - the longer the time, the
longer the battery life.
8
Enable LED Alert
Enable / disable LED flash when the alarm is triggered.
9
Temperature Low / High
Alarm
Configure the temperature low / high alarm level.
10
Relative humidity Low /
High Alarm
Configure the humidity low / high alarm level.
11
Default Button
Reload the factory default settings.
12
Setup Button
Save changes.
13
Close Button
Close this interface.