User manual

Voltsoft User Manual Version 2.4
49
6.3.4 DL131G – Settings
1
Time
Configure the device data time value.
User can specify a defined time or use the system date
time.
2
Logger Name
Input the unique alias for that device.
3
Sample Rate
Instruct the data logger to log readings at a specific
rate.
4
LED Flash RateCycle
Configure the LED flash cycle - the longer the time, the
longer the battery life.
5
Record Start Condition
By Button – The data logger will start recording only
after the user pressed the red button on
the device.
After Setup – The data logger will start recording
immediately after setup.
6
Motion Detection Threshold
Setup
The Motion Detection Threshold Setup filed allows the
user to set the acceleration detection threshold.Once
the acceleration value is over the threshold,the
DATALOGGER will work.
7
Recording Mode
The DATA LOGGER Record Mode can be set as Normal
and Motion Detection.
8
Default Button
Load the factory default settings.
9
Setup Button
Save changes.
10
Close Button
Close this interface.