User manual

Voltsoft User Manual Version 2.4
57
6.4.4 DL141TH – Settings
1
Device Time
Configure the device data time value.
User can specify a defined time or use the system date
time.
2
Logger Name
Enter the unique alias for that device.
3
Record Start Condition
By Button – The data logger will start recording only
after the user presses the red button on
the device.
After Setup – The data logger will start recording
immediately after setup.
Sample Rate
Instruct the data logger to log readings at a specific
rate. The user can input specific data in the edit box on
the left and select the time unit using the combo box
on the right.
5
Recording Time
Calculate the recording time based on the selected
sample points and sample rate.
6
LED Flash Cycle
Configure the LED flash cycle - the longer the time, the
longer the battery life.
7
Recording
Instruct the data logger to continue logging data,
recording over the earlier data (Circulating Record), or
to stop logging (No Circulating) when the data logger
memory is full.
8
Enable LED Alert
Enable / disable LED flash when the alarm is triggered.
9
Temperature Low / High
Alarm
Configure the temperature low / high alarm level.
10
Humidity Low / High Alarm
Configure the humidity low / high alarm level.
11
Default Button
Reload the factory default settings.
12
Setup Button
Save changes.
13
Close Button
Close this interface.