User manual

9. MEMORY SLOT OPERATION “PRESET” AND “SET”

Three xed voltages, including current settings, can be stored in the device with the Set function and

directly selected through the Preset function.

Ex works, all three memory slots (P1, P2, P3) are preset.

They are assigned as follows:

Memory

Type

P1 P2 P3

Voltage Current Voltage Current Voltage Current

DPPS-16-30 5 V Maximum 13.8 V Maximum 15 V Maximum

DPPS-32-15 5 V Maximum 13.8 V Maximum 25 V Maximum

DPPS-60-8 5 V Maximum 13.8 V Maximum 55 V Maximum

DPPS-16-40 5 V Maximum 13.8 V Maximum 15 V Maximum

DPPS-32-20 5 V Maximum 13.8 V Maximum 25 V Maximum

DPPS-60-10 5 V Maximum 13.8 V Maximum 55 V Maximum

DPPS-16-60 5 V Maximum 13.8 V Maximum 15 V Maximum

DPPS-32-30 5 V Maximum 13.8 V Maximum 25 V Maximum

DPPS-60-15 5 V Maximum 13.8 V Maximum 55 V Maximum

Make sure that no consumers are connected.

The memory can also be set via the software provided, check the chapter “Control with the

PC software”.

1. Activate the Preset function through the selection switch MODE (8) on the rear.

2. Put the switch in the Preset position. The front LED

indicator REAR CONTROL (2) lights up. The front

control knobs are now inactive.

3. Select the respective memory slot P1, P2 or P3 on

the rear selection switch RECALL (9). The

respective

output voltage is indicated on the display (1).

4. Now you can connect and switch on the consumer.