Information

USB configuration for remote programming
This application note describes the procedure to configure the USB port for remote programming application.
remote programmable power supply with USB can connected to PC through USB cable.
US
B to serial bridge design is used. When connected to PC, it will be converted as COM port shown in the following
picture. e.g. COM3
If the COM port does not come up, please check if the USB driver has been probably installed.
The USB driver comes with
software CD. Make sure the CD has been load to computer first.
Then it can program as stand COM port.
T
he default COM port setting;
baud rate : 9600
Data bits : 8 bit
stop bit : 1
Parity : None