User manual

ManualsBrandsVOLTCRAFT ManualsLaboratory Test EquipmentDigital 200 MHz 2-channel 500 null 512 null 8 Bit Digital storage (DSO)

Specifications

DSO-1000D Digital Oscilloscope User Manual 65

Pulse Width Range Selectable from 20ns to 10s

Slope Trigger

Slope Trigger Mode

Trigger when < (Less than), > (Greater than), = (Equal), or ≠ (Not Equal);

Positive slope or Negative slope

Slope Trigger Point

Equal: The oscilloscope triggers when the waveform slope is equal to the

set slope.

Not Equal: The oscilloscope triggers when the waveform slope is not

equal to the set slope.

Less than: The oscilloscope triggers when the waveform slope is less

than the set slope.

Greater than: The oscilloscope triggers when the waveform slope is

greater than the set slope.

Time Range Selectable from 20ns to 10s

Overtime Trigger The leading edge: Rising edge or Falling edge; Time Setting: 20-10s

Swap Trigger

CH1 Internal Trigger: Edge, Pulse Width, Video, Slope

CH2 Internal Trigger: Edge, Pulse Width, Video, Slope

Trigger Frequency

Counter

Readout Resolution 6 digits

Accuracy (typical) ±30ppm (including all frequency reference errors and ±1 count errors)

Frequency Range AC coupled, from 4Hz minimum to rated bandwidth

Signal Source

Pulse Width or Edge Trigger modes: all available trigger sources

The Frequency Counter measures trigger source at all times, including

when the oscilloscope acquisition pauses due to changes in the run

status, or acquisition of a single shot event has completed.

Pulse Width Trigger mode: The oscilloscope counts pulses of significant

magnitude inside the 1s measurement window that qualify as triggerable

events, such as narrow pulses in a PWM pulse train if set to < mode and

the width is set to a relatively small time.

Edge Trigger mode: The oscilloscope counts all edges of sufficient

magnitude and correct polarity.

Video Trigger mode: The Frequency Counter does not work.

Acquisition

Acquisition Modes Normal, Peak Detect, and Average

Acquisition Rate,

typical

Up to 2000 waveforms per second per channel (Normal acquisition mode,

no measurement)

Single Sequence Acquisition Mode Acquisition Stop Time

Normal, Peak Detect

Upon single acquisition on all

channels