Instructions

4
.
Panel Operation
10
Output Sine Wave
Press , the screen displays the user interface of the sine wave. By operating the
sine wave menu on the right side of the screen, you can set the output waveform
parameters of the sine wave.
The sine wave menu includes: frequency/period, amplitude/high level, offset/low
level, and start phase. The menu can be operated by the menu selection button on
the right.
Figure 4- 1: Sine wave user interface
Set the frequency/period
 Press CH1, all currently selected CH1 menu items are highlighted
 Press the Frequency/Period soft key, the currently selected menu item is
highlighted, and the corresponding parameter item is displayed in parameter 1.
Press the Frequency/Period softkey again to switch the frequency and period.
There are two ways to change the selected parameter value:
 Turn the knob to increase or decrease the value at the cursor. Press the /
arrow key to move the cursor left or right.
 Press a number key on the numeric keypad directly, the screen will pop out the
data input box, input the desired value. Press the X soft key to delete the last
digit, press the ← soft key to cancel the input, and press the Enter soft key to
indicate the default unit input. Press the MHz, kHz, Hz, mHz, uHz soft keys to