Instructions

4
.
Panel Operation
11
select the unit of the parameter. Press the Cancel softkey to cancel the current
input parameter value.
Figure 4- 2: Use the numeric keypad to set the frequency
Set the amplitude
Press the Amplitude/High Level softkey to confirm whether the Amplitude menu
item is highlighted; if not, press the Ampl/High button to switch to Amplitude. In
parameter 2 of Figure 5-1, the parameter value of the amplitude appears as a
blinking cursor. Use the knob or numeric keypad to set the desired value.
Set the offset
Press the Offset/Low Level softkey to confirm whether the Offset menu item is
highlighted; if not, press the Offset/Low level key to switch to Offset. In parameter 3
of Figure 5-1, the parameter value of the offset appears as a blinking cursor. Use the
knob or numeric keypad to set the desired value.
Set the high level
Press the Amplitude/High level button to confirm whether the “High level” menu
item is highlighted; if not, press the Ampl/High level button to switch to “High level”.
In parameter 2 of Figure 5-1, a high-level parameter value appears as a blinking
cursor. Use the knob or numeric keypad to set the desired value.
Set the low level
Press the Off/Low level button to confirm whether the “Low level” menu item is
highlighted; if not, press the Offset/Low level button to switch to “Low level”. In