Instructions

4
.
Panel Operation
12
parameter 3 of Figure 5-1, a low-level parameter value appears as a blinking cursor.
Use the knob or numeric keypad to set the desired value.
Set the start phase
Press the Start Phase softkey to confirm whether the Start Phase menu item is
highlighted; if not, press the Start Phase key. In parameter 4 of Figure 5-1, the
parameter value of the starting phase appears as a blinking cursor. Use the knob or
numeric keypad to set the desired value
Output Square Wave
Press , the screen displays the square wave user interface. By operating the
square wave menu on the right side of the screen, you can set the square wave
output waveform parameters.
The square wave menu includes: frequency / period, amplitude / high level, offset /
low level, starting phase.
For the setting frequency/period, amplitude/high level, offset/low level, and starting
phase, please refer to Output Sine Wave on page 10.
Figure 4- 3: Square wave user interface