Instructions
Table Of Contents
- 1.General Safety Requirement
- 2.Safety Terms and Symbols
- 3.Quick start
- 4.Panel Operation
- Channel Setting
- Waveform Setting
- Output the modulated waves
- Hexadecimal frequency shift keying (3FSK)
- Quaternary frequency shift keying (4FSK)
- Binary phase shift keying (BPSK)
- Oscillating keying (OSK)
- Output the sweep frequency (Sweep)
- Output the burst (Burst)
- Counter
- Utility function setting
- Edit the Arbitrary Wave (Edit)
- File system (Store)
- Save/recall instrument settings (Preset)
- Use build-in help (Help)
- 5.Communicate with PC
- 6.Troubleshooting
- 7.Specification
- 8.Appendix
4
.
Panel Operation
42
Steps to set frequency shift keying modulation
(1) After pressing the Mod function key, press the Modulation type soft key, use
the knob to select the modulation type as OSK, and press the enter key. The
carrier waveform can be selected as needed. The following is a sine wave.
(2) Press to display the waveform and parameters of the current carrier.
You can change the parameters of the carrier. For details, please refer to
Output Sine Wave on page 10. Press or Mod to return to the
modulation mode interface.
(3) Press the key frequency. The soft key sets the key rate. The range is from 2
mHz to 1 MHz.
(4) Press Vibration Time to select the vibration time, ranging from 8ns to
499.75μs.