Instructions
Table Of Contents
- 1.General Safety Requirement
- 2.Safety Terms and Symbols
- 3.Quick start
- 4.Panel Operation
- Channel Setting
- Waveform Setting
- Output the modulated waves
- Hexadecimal frequency shift keying (3FSK)
- Quaternary frequency shift keying (4FSK)
- Binary phase shift keying (BPSK)
- Oscillating keying (OSK)
- Output the sweep frequency (Sweep)
- Output the burst (Burst)
- Counter
- Utility function setting
- Edit the Arbitrary Wave (Edit)
- File system (Store)
- Save/recall instrument settings (Preset)
- Use build-in help (Help)
- 5.Communicate with PC
- 6.Troubleshooting
- 7.Specification
- 8.Appendix
4
.
Panel Operation
51
level of the part under test. The load impedance settings provided are only for the
convenience of the user to match the display voltage to the desired load.
The step to set the CH1 or CH2 load value is as follows:
(1) Press the Utility function button to select the CH1/2 setting. Press CH1 Load to
select CH1 load, or press CH2 Load to select CH2 load; press again to switch to
high impedance or *ohm ("*" represents a value).
(2)
To change the resistance value, after selecting *ohm in the previous step, turn
the knob to change the current cursor position value, press the / arrow
key to move the cursor left or right, or use the numeric keypad to input the
value. The input load range is from 1 ohm to 10k ohm.
Warning:
Each output of the front panel has a fixed 50 Ω series output impedance, regardless
of the value specified for this parameter. If the actual load is different from the
specified value, the displayed voltage level does not match the actual level.
Interface Setting
(1) Press the Utility function key, select the interface setting, and press the USB
device soft key to switch the USB device.
Set the communication protocol type of the USB Device interface on the
rear panel.
PC: This is the internal communication protocol. Select this option when
connecting to the ultrawave host computer software via the USB Device
interface.
USBTMC: Select this when you need to use the USBTMC communication
protocol standard.
(2) Press the Network Settings button and select Network Settings to go to the next
level menu: IP Address, Gateway, Subnet Mask, Port. The physical address
displayed on the interface cannot be modified. After setting the network
parameters such as the IP address of the user-defined signal generator, you
need to wait for 2S or more to restart the machine.
Press IP Address to select the IP address. Use the numeric keypad and the
rotary keys to enter the desired IP address. The format of the IP address is
nnn.nnn.nnn.nnn. The first nnn ranges from 1 to 223 (except 127), and the