Instructions
Table Of Contents
- 1.General Safety Requirement
- 2.Safety Terms and Symbols
- 3.Quick start
- 4.Panel Operation
- Channel Setting
- Waveform Setting
- Output the modulated waves
- Hexadecimal frequency shift keying (3FSK)
- Quaternary frequency shift keying (4FSK)
- Binary phase shift keying (BPSK)
- Oscillating keying (OSK)
- Output the sweep frequency (Sweep)
- Output the burst (Burst)
- Counter
- Utility function setting
- Edit the Arbitrary Wave (Edit)
- File system (Store)
- Save/recall instrument settings (Preset)
- Use build-in help (Help)
- 5.Communicate with PC
- 6.Troubleshooting
- 7.Specification
- 8.Appendix
4
.
Panel Operation
54
menu is “Factory Settings” to press the “Reset” soft key for factory setting. ). The
factory default parameter values are as follows
Output Configuration
Factory Setting
CH1 signal output switch
OFF
CH2 signal output switch
OFF
Function
Sine
Frequency
1 kHz
Amplitude/offset
1 Vpp / 0 Vdc
Waveform Configuration
Factory Setting
Frequency
1.000kHz
Period
1.000ms
Amplitude
1.000Vpp
Offset
0.000V
High Level
500mV
Low Level
-500mV
Start Phase
0deg
Symmetry
50%
Pulse Width
500.000us
Duty Cycle
50.00%
Rising Time
1.953125us
Falling Time
1.953125us
Build-in Wave
X^2
Harmonic Wave Type
Even harmonic
Harmonic Wave Times
2
Number
2
Harmonic Wave Amplitude
1.000Vpp
Harmonic Wave Phase
0deg
Modulation Waveform
Factory Setting
Modulation type
AM
Modulated waveform
Sine
Amplitude modulation
frequency
100.000Hz