Instructions
Table Of Contents
- 1.General Safety Requirement
- 2.Safety Terms and Symbols
- 3.Quick start
- 4.Panel Operation
- Channel Setting
- Waveform Setting
- Output the modulated waves
- Hexadecimal frequency shift keying (3FSK)
- Quaternary frequency shift keying (4FSK)
- Binary phase shift keying (BPSK)
- Oscillating keying (OSK)
- Output the sweep frequency (Sweep)
- Output the burst (Burst)
- Counter
- Utility function setting
- Edit the Arbitrary Wave (Edit)
- File system (Store)
- Save/recall instrument settings (Preset)
- Use build-in help (Help)
- 5.Communicate with PC
- 6.Troubleshooting
- 7.Specification
- 8.Appendix
4
.
Panel Operation
57
Edit the Arbitrary Wave (Edit)
Press the front panel Edit function key to enter the arbitrary wave editing
interface.
(1) Set the number of waveform points: Press the number of waveform
points softkey, use the knob to change the value directly or use the
numeric keypad to input and select the unit softkey. The number of points
ranges from 2 to 100,000.
(2) Set interpolation (only for the model without touchscreen): Press the
Interpolate softkey to toggle the interpolation on/off. Select On to connect
each waveform point with a straight line; select Off, the voltage level
between each waveform point remains the same, creating a waveform
Accessibility
Factory Setting
Backlight
100%
Screen saver
turn on
Screen saver time
30Minute
Separator
Space
CH1 synchronization
shut down
CH2 synchronization
shut down
CH1 load
50ohm
CH2 load
50ohm
USB device
USBTMC
IP address
192.168.1.99
Gateway
192.168.1.1
Subnet mask
255.255.255.000
Port
3000
Language
Subject to the actual machine
Buzzer
turn on
Clock source
internal
Between Channels
Factory Setting
Frequency lock
Off
Amplitude lock
Off