Instructions
Table Of Contents
- 1.General Safety Requirement
- 2.Safety Terms and Symbols
- 3.Quick start
- 4.Panel Operation
- Channel Setting
- Waveform Setting
- Output the modulated waves
- Hexadecimal frequency shift keying (3FSK)
- Quaternary frequency shift keying (4FSK)
- Binary phase shift keying (BPSK)
- Oscillating keying (OSK)
- Output the sweep frequency (Sweep)
- Output the burst (Burst)
- Counter
- Utility function setting
- Edit the Arbitrary Wave (Edit)
- File system (Store)
- Save/recall instrument settings (Preset)
- Use build-in help (Help)
- 5.Communicate with PC
- 6.Troubleshooting
- 7.Specification
- 8.Appendix
5
.
Communicate with PC
64
(4)
Set the network parameters of the signal generator. In the signal generator,
press Utility → I/O Setup → Network setting to enter the submenu. Set the IP
address and port to the IP and port in the PC software port settings in step (3).
The gateway settings need to be the same as the gateway settings of the router.
After the shutdown and restart, if the data can be obtained normally in the PC
software, the connection is successful.
For the specific operation method of Waveform Editor software, please press F1 to
view the built-in help documentation.