Instructions
Table Of Contents
- 1.General Safety Requirement
- 2.Safety Terms and Symbols
- 3.Quick start
- 4.Panel Operation
- Channel Setting
- Waveform Setting
- Output the modulated waves
- Hexadecimal frequency shift keying (3FSK)
- Quaternary frequency shift keying (4FSK)
- Binary phase shift keying (BPSK)
- Oscillating keying (OSK)
- Output the sweep frequency (Sweep)
- Output the burst (Burst)
- Counter
- Utility function setting
- Edit the Arbitrary Wave (Edit)
- File system (Store)
- Save/recall instrument settings (Preset)
- Use build-in help (Help)
- 5.Communicate with PC
- 6.Troubleshooting
- 7.Specification
- 8.Appendix
6
.
Troubleshooting
65
6. Troubleshooting
1. If the instrument is still black and there is no display when you press the power
switch, please follow the steps below:
Check if the power connector is connected.
Check that the voltage selector is in the correct gear position.
Check that the fuse at the power connector meets the specified type and
rating and is blown (can be opened with a flat-blade screwdriver).
After completing the above checks, restart the instrument.
If you still cannot use this product, please contact us and let us serve you.
2. The measured value of the output signal amplitude does not match the
displayed value:
Check that the actual load value of the signal is consistent with the load value set by
the system. For details, please refer to Set the load on page 50.
If you encounter other problems, please try resetting the settings (see Clock source
on page 52) or reboot. If you still cannot use this product, please contact us and let
us serve you.