Instructions
Table Of Contents
- 1.General Safety Requirement
- 2.Safety Terms and Symbols
- 3.Quick start
- 4.Panel Operation
- Channel Setting
- Waveform Setting
- Output the modulated waves
- Hexadecimal frequency shift keying (3FSK)
- Quaternary frequency shift keying (4FSK)
- Binary phase shift keying (BPSK)
- Oscillating keying (OSK)
- Output the sweep frequency (Sweep)
- Output the burst (Burst)
- Counter
- Utility function setting
- Edit the Arbitrary Wave (Edit)
- File system (Store)
- Save/recall instrument settings (Preset)
- Use build-in help (Help)
- 5.Communicate with PC
- 6.Troubleshooting
- 7.Specification
- 8.Appendix
8
.
Appendix
73
8. Appendix
Appendix A: Accessories
A power cord that meets the standards of the country where you are located
A USB communication cable
A CD
A Safety hintsheet
Two BNC/Q9 lines
Appendix B: Maintenance and cleaning
General maintenance
Do not store or place the instrument where the LCD monitor will be exposed to
direct sunlight for long periods of time.
Cautious: Do not allow sprays, liquids, and solvents to get on the instrument to
avoid damaging the instrument.
Cleaning
The instrument is often checked for usage. Follow the steps below to clean the
outer surface of the instrument:
1. Wipe the dust on the outside of the instrument with a soft cloth. When
cleaning the LCD screen, be careful not to scratch the transparent LCD screen.
2. Wipe the instrument with a soft cloth that is damp but not dripping. Please
pay attention to disconnect the power supply. It can be scrubbed with a mild
detergent or water. Do not use any abrasive chemical cleaners to avoid
damaging the instrument.
Warning: Before re-energizing, please confirm that the instrument has dried
out to avoid electrical short circuit or even personal injury due to
moisture.