Instructions

4.Panel Operation

Press the Harmonic Type softkey menu and the instrument outputs the fundamental and even

harmonics.

Odd harmonic

Press the Harmonic Type softkey menu and the instrument outputs the fundamental and odd

harmonics.

Order harmonic

Press the Harmonic Type softkey menu and the instrument outputs the fundamental and

harmonics in sequence.

customize

Press the Harmonic Type softkey to customize the number of times the harmonics are output.

The maximum number of times is 16. The 16-bit binary data is used to represent the output state

of the 16th harmonic, respectively, 1 means the output of the corresponding subharmonic is

turned on, and 0 means the output of the corresponding subharmonic is turned off. The user

only needs to use the numeric keypad to modify the value of each data bit (note: the leftmost bit

indicates the fundamental wave, fixed to X, and modification is not allowed). For example, set

16-bit data to X001 0000 0000 0001, indicating the output fundamental, 4th harmonic, and 16th

harmonic. Note: The harmonics of the actual output are limited by the currently specified

“harmonic times”.

Set the harmonic times

Press the Next soft key to enter the next page, and then press the Harmonic Times softkey to

confirm whether the “Harmonic Times” menu item is highlighted; if not, press the Harmonic

Times softkey. In parameter 5 of Figure 5-11, the parameter value of the harmonic order appears

as a blinking cursor. Use the knob or numeric keypad to set the desired value, which can be set

from 2 to 16 times.

Set the harmonic number

Press the Next soft key to enter the next page, and then press the Sequence soft key to confirm

whether the “Number” menu item is highlighted; if not, press the Sequence soft key. In

parameter 6 of Figure 5-11, the parameter value of the serial number appears as a blinking cursor.

Use the knob or numeric keypad to set the desired value, which can be set from 2 to 16 times.

Set the harmonic amplitude

Press the Next soft key to enter the next page, and then press the Harmonic Amplitude softkey

to confirm whether the “Harmonic Amplitude” menu item is highlighted; if not, press the

Harmonic softkey soft key. In parameter 7 of Figure 5-11, the parameter value of the harmonic

amplitude appears as a blinking cursor. Use the knob or numeric keypad to set the desired value.

Set the harmonic phase

Press Next to enter the next page, and then press the Harmonic Phase softkey to confirm

whether the “Harmonic Phase” menu item is highlighted; if not, press the Harmonic Phase

softkey. In parameter 8 of Figure 5-11, the parameter value of the harmonic phase appears as a

blinking cursor. Use the knob or numeric keypad to set the desired value.