Instructions

4.Panel Operation

4. Panel Operation

Channel Setting

Select the channel for configuration

Before configuring waveform parameters, you must select the channel you want to

configure. Press CH1 or CH2 to select the corresponding channel, and the

corresponding channel area in the user interface will light up

Turn On/Off Channel Output

Press the front panel CH1 On/Off or CH2 On/Off button to turn the output of the

corresponding channel on/off. When the output is turned on, the backlight of the

button lights up.

Channel Copy

(1) Press CH1⇌CH2 on front panel to display copy menu.

(2) Select CH2 to CH1 softkey or CH1 to CH2 softkey to copy the channel.

Waveform Setting

Sine, square, ramp, pulse, noise, arbitrary or harmonic waves can be set and output.

Press the waveform selection button on the instrument front panel: sine

square

, ramp , pulse , noise , arbitrary wave , harmonic

, and enter the corresponding waveform setting interface. The waveform is

different and the parameters that can be set are different.

Note: The following setting waveform uses CH1 channel as an example. If you need

to set CH2 channel, please refer to CH1 channel specific operation.