Instructions

4.Panel Operation
18
Set the rising/falling time
Press the rise time / fall time soft key to select the "rise time / fall time" menu item,
as shown in Figure 5-6, parameter 6 shows the current value of the rise/fall time;
press the rise time / fall time key to switch between the current display. Parameter
value.
Set the rise time/fall time parameter value Use the knob or use the numeric keypad
to enter the value, then select the desired unit from the right menu, press the
desired unit (ks, s, ms, us, ns) or Enter the value; press the X soft key to delete the
last digit, press the ← soft key to cancel the input, press the Enter softkey to
indicate the default input.
Output Noise Wave
The noise wave output by the system is white noise. Press , the screen displays
the user interface of the noise wave. By operating the noise wave menu on the right
side of the screen, the output waveform parameters of the noise wave can be set.
The noise wave has no frequency and periodic parameters, and the bandwidth is 120
MHz of Gaussian noise.
The menu of noise waves includes: amplitude / high level, offset / low level.
For the setting of amplitude/high level, offset/low level, please refer to Output Sine
Wave on page 10.