Instructions

4.Panel Operation
30
can change the parameters of the carrier. For details, please refer to Output Sine
Wave on page 10. Press or Mod to return to the modulation mode
interface.
(3) Press Source to select the source. If External is selected, connect the external
signal source to the Ext Mod In interface on the rear panel and skip to step (5).
If you select Internal, continue with the following steps.
(4) Press Modulation Waveform to select the modulation waveform type. You can
select Sine, Square, Ramp, Noise, or Arb.
(5) Press Modulation Frequency to set the modulation frequency value. The
modulation frequency ranges from 2 mHz to 100 kHz (for internal sources only).
(6) Press the Frequency Offset softkey to set the frequency offset value. Frequency
offset range: 2 mHz ≤ offset ≤ min (min is the carrier frequency or carrier
maximum frequency - carrier frequency) by default, the smaller of the two.