User manual

56
The “O P PFF” display is lit. The DC output was switched off through the remote control
output (10). Release the connection between contacts 4 and 5.
The output is switched on again.
The output current is limited to
5 A, although the current settings
are higher.
The output current is limited to 5 A. For higher currents,
connect the consumer to the rear main output.
The “C.C.” LED is lit. Constant current operation:
The preset current was exceeded. Check power consumption
on your consumer and increase the current limitation on your
power unit, if applicable.
The “C.V.” LED is lit. Constant voltage operation:
The power unit works normally. The output provides the
constant voltage set.
OVP Over-voltage protection:
See chapter PROTECTIVE MEASURES.
OtP Overheating protection:
See chapter PROTECTIVE MEASURES.
OLP Overload-protection:
See chapter PROTECTIVE MEASURES.
Repairs other than those described above may only be carried out by an authorised
specialist.
16. DISPOSAL
Electronic devices are recyclable waste and must not be disposed of in the household
waste!
At the end of its service life, dispose of the product according to the relevant statutory
regulations.