User manual

25
Avoid sudden temperature fluctuations! This may easily lead to condensation inside the device! In this
case, the device must be adjusted to the new ambience temperature before start up for at least one hour
in a well-ventilated place.
The converter heats up in operation; ensure that it is adequately ventilated. Do not cover the ventilation
apertures of the device!
Do not leave converters and the connected consumers running without supervision.
Ensure sufficient ventilation of the DC-AC converter and the batteries. Battery vapours may ignite because of
the DC-AC converter Therefore, the battery and the converter must be installed in separate spaces.
Do not connect the 230 V output of the DC-AC converter with another 230 V source.
The converter is not designed for application to human beings or animals or for life-supporting medical
devices.
Never expose the device to mechanical stress. Dropping the device even from a low height may damage
it! Avoid vibrations and direct sunlight.
If you have reason to believe that the device can no longer be operated safely, disconnect it immediately
and make sure it is not unintentionally operated. It must be assumed that safe operation is no longer pos-
sible if:
- the device shows visible damage,
- the device no longer works and
- the device was stored under unfavourable conditions for a long period of time or
- after it was exposed to extraordinary stress caused by transport.
Observe also the additional safety instructions in each chapter of these operating instructions as well as in
the operating instructions of the connected devices.
Observe that parts of the converter will continue to be live after the protective device (fuse) is triggered!
Handle the product with care. It can be damaged through impact, blows, or accidental drops, even from a
low height. Have the device checked by trained specialists in this case before recommissioning.
If you notice any damage, the device must not be used anymore. Take the device to a specialized work-
shop or dispose of it in an environmentally friendly way.
Damaged connection cables must be exchanged to prevent hazards! Only use suitably sized connection
cables (see “Technical Data”).
Repairs on this device may only be performed by specialists. Improper repairs may result in substantial
hazards! In case of repairs, contact our service department.
Never use the device on hot surfaces. Make sure that ventilation slots are not covered up. Protect the
converter from heat! If the converter heats up too far due to excessive ambience temperatures, the
overheating protection switches off the device to prevent subsequent damage. In this case, wait until the
device has cooled off.
When using the device in vehicles, secure it properly to ensure correct operation of the vehicle.
Prior to activating the device, make sure that the cable and plug are dry. Never operate the device with
wet hands.
Only operate the device under supervision.