Instructions
Table Of Contents
- 1.General Safety Requirements
- 2.Safety Terms and Symbols
- 3.Junior User Guidebook
- Introduction to the Structure of the Oscilloscope
- User Interface Introduction
- How to Implement the General Inspection
- How to Implement the Function Inspection
- How to Implement the Probe Compensation
- How to Set the Probe Attenuation Coefficient
- How to Use the Probe Safely
- How to Implement Self-calibration
- Introduction to the Vertical System
- Introduction to the Horizontal System
- Introduction to the Trigger System
- Touchscreen Controls
- Magnifier Function
- 4.Advanced User Guidebook
- How to Set the Vertical System
- Use Mathematical Manipulation Function
- Use Vertical Position and Scale Knobs
- How to Set the Horizontal System
- How to Set the Trigger/Decoding System
- How to Operate the Function Menu
- How to Implement Sampling Setup
- How to Set the Display System
- How to Save and Recall a Waveform
- How to Record/Playback Waveforms
- How to Clone and Recall a waveform
- How to Implement the Auxiliary System Function Set
- How to Update your Instrument Firmware
- How to Measure Automatically
- How to Measure with Cursors
- How to Use Autoscale
- How to Use Built-in Help
- How to Use Executive Buttons
- How to Print the Screen Image
- 5.Use the Arbitrary Function Generator (Optional)
- 6.Use the Multimeter (Optional)
- 7.Communication with PC
- 8.Demonstration
- 9.Troubleshooting
- 10.Technical Specifications
- 11.Appendix
6.Use the Multimeter (Optional)
109
10. When internal storage is selected: You can export the internal record file to a USB
memory device. Insert the USB memory device into the front-panel USB port on your
instrument. Select Export in the bottom menu. The instructions will be shown on the
screen. The export file will be named as "Multimeter_Recorder.csv". If a file with the
same name already exists in the USB memory device, it will be overwritten. (If you
want to keep the existing file, back up it to other location in advance.) Select Export
in the bottom menu to export.
How to chart the data
You can open the CSV file using Microsoft Excel, or your favorite spreadsheet application,
and create charts based on the data.
In the following steps, Microsoft Excel 2010 is used as an example.
1. Open Multimeter_Recorder.csv in Excel.
2. Select the data that you want to chart (see Figure 6- 4).
3. On the Insert tab, in the Charts group, click Line, and then click Line in 2-D Line
(see Figure 6- 5).