Instructions
Table Of Contents
- 1.General Safety Requirements
- 2.Safety Terms and Symbols
- 3.Junior User Guidebook
- Introduction to the Structure of the Oscilloscope
- User Interface Introduction
- How to Implement the General Inspection
- How to Implement the Function Inspection
- How to Implement the Probe Compensation
- How to Set the Probe Attenuation Coefficient
- How to Use the Probe Safely
- How to Implement Self-calibration
- Introduction to the Vertical System
- Introduction to the Horizontal System
- Introduction to the Trigger System
- Touchscreen Controls
- Magnifier Function
- 4.Advanced User Guidebook
- How to Set the Vertical System
- Use Mathematical Manipulation Function
- Use Vertical Position and Scale Knobs
- How to Set the Horizontal System
- How to Set the Trigger/Decoding System
- How to Operate the Function Menu
- How to Implement Sampling Setup
- How to Set the Display System
- How to Save and Recall a Waveform
- How to Record/Playback Waveforms
- How to Clone and Recall a waveform
- How to Implement the Auxiliary System Function Set
- How to Update your Instrument Firmware
- How to Measure Automatically
- How to Measure with Cursors
- How to Use Autoscale
- How to Use Built-in Help
- How to Use Executive Buttons
- How to Print the Screen Image
- 5.Use the Arbitrary Function Generator (Optional)
- 6.Use the Multimeter (Optional)
- 7.Communication with PC
- 8.Demonstration
- 9.Troubleshooting
- 10.Technical Specifications
- 11.Appendix
7.Communication with PC
115
(4) Set the network parameters of the oscilloscope. In the oscilloscope, push the Utility
button. Select Function in the bottom menu. Select LAN Set in the left menu. In the
bottom menu, set the Type item as LAN, and select Set. In the right menu, set IP and
Port to the same value as the "Ports-settings" in the software in step (3). The Netgate
and Net mask should be set according to the router. Select Save set in the bottom
menu, it prompts "Reset to update the config". After resetting the oscilloscope, if you
can get data normally in the oscilloscope software, the connection is successful.
Figure 7- 7 Set the network parameters of the oscilloscope