Manualshelf

Instructions

ManualsBrandsVOLTCRAFT ManualsFunction GeneratorsMains-powered FG-2502 1uHz - 50 MHz 2-channel Arbitrary, Noise, Pulse, Rectangle, Sinus, Triangle, Waveform Manufacturer
21222324252627282930
5.Front Panel Operation
26
page 12. Press button again to return to the Modulation mode interface.
(4) Press F5 to select the source. If the source is External, use the Ext Mod In
connector in the rear panel to input the external signal, then skip ahead to step (7). If
you choose Internal, continue to the steps below.
(5) Press F2 to choose Mod Shape, you can choose Sine, Square ,Ramp, Noise or
Arb .
(6) Press F3 to set PM Frequency. The range is 2 mHz - 20 kHz (Internal source only).
(7) Press F4 to set Phase Deviation. The Phase Deviation between the Modulating
Waveform and the Carrier Waveform ranging from 0° to 180°.
PWM (Pulse Width Modulation)
The modulated waveform consists of two parts: the Carrier Waveform and the
Modulating Waveform. PWM can only be used for pulse modulation, so the Carrier
Waveform must be Pulse. In PWM, the width of the Carrier Waveform (Pulse) varies with
the instantaneous voltage of the modulating waveform.
How to set the parameters of PWM
(1) Press Mod function button, then press F1 to select Mod.
(2) Press F1 to switch Mod Type to PWM. If the Carrier Waveform is not Pulse, the
system will switch it to Pulse automatically.
(3) Press button to display the waveform and parameters of the Carrier
Waveform. You can change the parameters, please refer to To Output Pulse Signals
on page 16. Press button again to return to the Modulation mode interface.
(4) Press F5 to select the source. If the source is External, use the Ext Mod In
connector in the rear panel to input the external signal, then skip ahead to step (7). If
you choose Internal, continue to the steps below.
(5) Press F2 to choose Mod Shape, you can choose Sine, Square ,Ramp or Arb .
(6) Press F3 to set Mod Frequency. The range is 2 mHz - 20 kHz (Internal source
only).
(7) Press F4 to set Width Deviation/Duty Deviation (depends on the P_Width/Duty
menu item of the Pulse setting menu when you exit the Modulation mode). The
maximum range of the Duty Deviation is the smaller one in [Pulse Duty, 1-Pulse Duty].
The maximum range of the Width Deviation is Pulse Width.
FSK (Frequency Shift Keying)
The FSK Modulation is a modulation method, the output frequency of which switches
between two the pre-set frequencies (Carrier Waveform Frequency and the Hop
Frequency). The Frequency of the Output Frequency switch between the carrier
waveform frequency and the Hop frequency is called the FSK rate. The frequency by
which the output frequency switch from each other is determined by the Internal