Instructions

5.Front Panel Operation
33
Set the Gated Burst
Current Parameter
Positive
Load
Start Phase
Gated
Waveform
Source
Figure 5-21: The User Interface of Gated Burst
(1) When the output signal is Sine, Square, Ramp, Pulse or Arbitrary waveform, press the
Mod button, then press F3 to select Burst.
(2) Press , , , or button to choose the waveforms. Take Sine
for instance, press to display the waveform and parameters. You can change
the parameters, please refer to To set signals on page 12. Press button again
to return to the Burst mode interface.
(3) Press F3 to switch to Gated.
(4) Press F2 to select Start Phase, define the Start and the Stop Point in a waveform.
The phase varies from -360° to +360°. For an Arbitrary Waveform, 0° is the first
waveform point.
(5) Press F5 to switch between Positive/Negative. Set the Polarity for the Gated
Signal.
To Save and Recall
Press Save function button to enter the file system.
To Use USB Storage
The storage location is divided into the internal storage (FLASH) and the USB device
storage (USBDEVICE). When a USB device is connected, the storage menu will show
"USBDEVICE" and "FLASH". Otherwise, the storage menu will show "FLASH" only.
(1) Install the USB device: insert a USB device into the "⑰USB port" on the front panel
in Figure 4-1, and the screen will show "Detect USB device". Press Save function
button to enter the file system, the storage menu will show "USBDEVICE" and
"FLASH".
(2) Enter the storage: Turn the knob or press / direction key to choose the
desired storage. Press F1 to enter the chosen storage. Provide operations as Next