Instructions

5.Front Panel Operation
35
To Set the Separator
The user can set the separator of the displayed parameter.
(1) Press Utility and choose Disp Setup, press F2 to select Sep.
(2) Press F2 to switch between Comma, Space, Off.
Take the Frequency parameter for instance:
Comma
Space
Off
To Set the Screen Saver
The screen saver will run automatically if no operation is taken for any key within the set
time. Press any button to resume.
(1) Press Utility and choose Disp Setup, press F3 to select Scrn Svr.
(2) Press F3 to switch between On/Off.
(3) If On is selected, you can set the screen saver time. Turn the knob to change the
value, press / direction key to move the cursor left and right; or press the
number keys to input the desired time in minutes, press F4 to select the unit.
The screen saver time range is 1 - 999 minutes.
To Set the Counter
The counter can measure the signal with frequency from 100 mHz to 200 MHz.
The operation steps:
(1) Press Utility and choose Counter.
(2) Connect the signal to the connector [Ref Clk/Counter In] on the rear panel.
(3) Press F3 to choose Set, enter measurement setting menu.
 To set the coupling mode: Press F1 to switch Coupling as AC/DC.
 To set the sensitivity: Press F2 to switch Sens as Low/Middle/High.
For low amplitude signal, the “Middle” or “High” sensitivity should be used.
For low frequency signal with high amplitude and slower rising edge, low
sensitivity is a better choice.
 To set the high frequency restrain on/off: Press F3 to switch HFR as ON/OFF.
High frequency restrain is used for filtering the high frequency signal in