Instructions

Data Transmission
A) General
We are (still) in the Main Menu. In this window, another small win-
dow appears, showing the text "Cannot find any thermometer".
This message appears if the connected thermometer is switched
OFF.
Switch on the thermometer and click on the "RETRY" item. If the
message does not change, there is a problem - either as regards
the thermometer (battery ?) or the connecting cable (perfect fit?) or
the software installation (setup fault ?). Start anew and try every
thing again.
The following message appears in case of type 300 K, if the
connection was established successfully (depending on computer):
"Serial Port : COM 1
Model : One Channel, K type thermometer"
The following message appears in case of type 303 K/J, if the
connection was established successfully (depending on computer):
"Serial Port : COM 1
Model : Two Channel, K J type thermometer"
Click on "OK" to close the window.
In the "Main Menu" window, you can click on wherever the mouse
pointer is transformed into a hand with forefinger:
The item "Graph" ("Real Time"), a graphic representation of the real
time measurement or
the "Control Panel" item, a representation of the thermometer's
control panel with display or
16
C) Control Panel
Cliquez sur l'élément "Control Panel". La partie avant de votre ther-
momètre 300 K ou 303 K/J avec affichage à changement automa-
tique est alors représentée. Vous pouvez à présent commander
votre thermomètre à l'aide de la souris de l'ordinateur de façon li-
mitée (certaines fonctions ne peuvent pas être remises à zéro).
Pour fermer la fenêtre "Control Panel", cliquez sur le "x" situé en
haut à droite.
D) Tabular
Cliquez sur l'élément "Tabular". Vous pouvez alors visualiser la re-
présentation continue sous forme de tableau des valeurs de
température T1 et T2 en temps réel. Vous trouverez ci-après une
brève description de chaque commande.
Sampling Rate
Cette commande vous permet de régler la fréquence d'échantillon-
nage, c'est-à-dire la vitesse / fréquence d'actualisation du contenu
de l'écran. Le temps de réglage max. est de 59 minutes et 59 se-
condes. Le réglage minimum est de 2 sec., en d'autres termes un
nouveau contenu d'écran (de nouvelles valeurs de mesure ; repor-
tez-vous à la dernière ligne) s'affiche toutes les 2 secondes.
? = Help
L'élément contenant le point d'interrogation équivaut à la fonction
Help = aide, dans laquelle chaque commande est expliquée.
Main Menu
Vous pouvez accéder au menu principal en cliquant sur cet élé-
ment.
Output to Graph (sortie vers le graphique) ou Icône à côté du point
d'interrogation :
29