Safety data sheet

© Copyright 2014, Voltivo Group Ltd.
Material Safety Datasheet
SECTION 1: Identification of the substance and of the company
Product identifier
Name: ExcelFil PLA 3D printing Filament (Polylactide Resin)
SKU: EF-PLA-XXX-XXXXX
Relevant identified uses of the substance or mixture and uses advised against
Use only in 3D FFD Printers
Details of the supplier of the safety data sheet
Company
Voltivo Group Ltd.
Address
7F, No.5, Alley 27, Lane 216, Sec. 4, Zhongxiao E. Road, 106 Taipei
Information Phone
[phone] (Customer Care)
Emergency Phone
[phone] (Customer Care)
SECTION 2: Hazards identification
Unusual Explosion Hazard
and Fire
The material will burn if exposed to sufficient heat and
an ignition source. Avoid dispersion of dust in the air to
reduce dust explosion hazard potential.
SECTION 3: Composition/information on ingredients
Chemical Name: Polylactide Resin
CAS Number: 9051-89-2
Common Names: Polylactic Acid, PLA
SECTION 4: First aid measures
Skin Contact
Solid or dust may cause irritation or corneal injury due
to mechanical action
Eyes Contact
Essentially nonirritating to skin, Mechanical injury only
Inhalation
No harmful effects expected. Consult a physician.
Swallowing
No harmful effects expected. Consult a physician.
SECTION 5: Firefighting measures
Unusual Explosion Hazard
and Fire
The material will burn if exposed to sufficient heat and
an ignition source. Avoid dispersion of dust in the air to
reduce dust explosion hazard potential.
Extinguished Media
Water, Carbon dioxide, Dry chemical power, Foam.
Special Extinguishing
Procedures
Firefighters must wear self-contained breathing
apparatus and fully protective equipment.
SECTION 6: Accidental release measures
Personal precautions: Use personal protective equipment. See Section 8. Remove all
sources of ignition. Avoid dust formation. Avoid contact with skin and eyes. Sweep up to
prevent slipping hazard.