Specifications

Schuko Type
Model with input power cord Model with AC terminal
 Input voltage range selector  External battery connector
 AC input  Charge current selector (10A or 20A)
 Input breaker  Output receptacles
3. Important Safety Warning (SAVE THESE INSTRUCTIONS)
Before using the inverter, please read all instructions and cautionary markings
on the unit, this manual and the batteries.
General Precaution-
CAUTION! The unit is designed for indoor use. Do not expose this unit to rain, snow or
liquids of any type.
CAUTION! To reduce risk of injury, only use qualified batteries from qualified distributors or
manufacturers. Any unqualified batteries may cause damage and injury. Do NOT use old or
overdue batteries. Please check the battery type and date code before installation to avoid
damage and injury.
WARNING! It's very important for system safety and efficient operation to use appropriate
external battery cable. To reduce risk of injury, external battery cables should be UL certified
and rated for 75° C or higher. And do not use copper cables less than 8AWG.
WARNING! It's very important for system safety. AC input cable should be UL certified and
rated for 105° C or higher. And do not use copper cables less than 18AWG.
CAUTION! Do not disassemble the inverter. Contact with the qualified service center when
service or repair is required.
WARNING! Provide ventilation to outdoors from the battery compartment. The battery
enclosure should be designed to prevent accumulation and concentration of hydrogen gas at
the top of the compartment.
CAUTION! Use insulated tools to reduce the chance of short-circuit when installing or
working with the inverter, the batteries, or other equipments attached to this unit.
CAUTION! For battery installation and maintenance, read the battery manufacturer's
installation and maintenance instructions prior to operating.
Personnel Precaution -
CAUTION! Careful to reduce the risk or dropping a metal tool on the batteries. It could spark
or short circuit the batteries and could cause an explosion.
CAUTION! Remove personal metal items such as rings, bracelets, necklaces, and watches
when working with batteries. Batteries can produce a short circuit current high enough to
make metal melt, and could cause severe burns.
CAUTION! Avoid touching eyes while working near batteries.
CAUTION! Have plenty of fresh water and soap nearby in case battery acid contacts skin,
clothing, or eyes.
CAUTION! NEVER smoke or allow a spark or flame in vicinity of a battery.
CAUTION! If a remote or automatic generator start system is used, disable the automatic
starting circuit or disconnect the generator to prevent accident during servicing.
4. Specifications
MODEL
850
1.5K
CAPACITY
850VA/600W
1500VA/1050W
INPUT
Voltage
230VAC
Voltage Range
180-260 VAC (For personal computer)
100-300 VAC (For home appliances)
OUTPUT
Voltage Regulation (Batt. Mode)
230VAC ± 10 %
Transfer Time
20 ms typical
Waveform
Simulated Sine Wave
BATTERY
Battery Voltage
12 VDC
24 VDC
Floating Charge Voltage
13.7 VDC ± 2%
27.4 VDC ± 2%
Maximum Charge Current
10 A or 20 A
Recommended Battery Capacity
100 Ah – 200 Ah
PHYSICAL
Dimension (DxWxH) mm
289 x 290 x 127
Net Weight (kgs)
9
12
5. Installation
NOTE: Before installation, please inspect the unit. Be sure that nothing inside the package is
damaged.
Assemble AC Input Cable (Only available for the unit with AC terminal)
Step 1- Take away the cover of AC input connector.
Step 2- Connect an input power cord to AC input terminal. Following AC input polarity (L, N,
GND) guide printed near the terminal! (Refer to below chart)
Conventions used:
WARNING! Warnings identify conditions or practices that could result in personal injury;
CAUTION! Caution identify conditions or practices that could result in damaged to the
unit or other equipment connected.