Operator`s manual

Auxiliary stop
If the engine cannot be stopped in a normal procedure,
it is possible to stop the engine via auxiliary stop
mounted on the side of the engine.
After Engine Shutdown
•
Check the engine and engine bay for leakages.
•
Close the fuel tap.
•
Close the sea cock where fitted.
•
Take an hour meter reading and carry out preven-
tive maintenance according to the maintenance
schedule.
•
Turn off the main switch before any long stoppage.
Operation break with the boat in water
If the boat is not used, but left in the water, the engine
must be warmed up at least once every fortnight. This
prevents corrosion damage in the engine.
If you expect the boat to be unused for two months or
more, it must be laid up, please refer to Short Term
Storage
Operation break with the boat out of water
Where boats are kept laid up on land when not in use,
there is a lower level of galvanic corrosion protection
due to oxidation on the sacrificial anodes. Before
launching the boat the sacrificial anodes on the drive
and shield must be cleaned with emery paper to
remove any oxidation.
10
10
STOP
1
P0004514
1
0
P0005914
Engine Shutdown
7748887 04-2008 37