Technical data

43
Repair instructions
13
Install the throwout ring on the shaft.
14
Install the ceramic portion of the seal, using mandrel
9994034.
Put a piece of plastic foil (from a plastic bag) on the
ceramic seal to protect it from grease and finger
marks.
15
Install the carbon track, using mandrel 9994034.
16
Install the wear track and install the comb with a small
amount of Permatex® No. 77 on the rear.
17
Grease the shaft and install the impeller by turning it
anti-clockwise. Use soapy water to facilitate insertion.
Install the small lid on the impeller.
Install the pump lid with a new gasket.
18
Install the key and gear wheel.
Tighten the nut.