Operating instructions

Lubricating chart

Check the following when filling the tank

Check the engine oil level.

Check without removing the cap that the level in the brake fluid container

is above the "Min" mark. (Right-hand steering: Check also the clutch fluid

level.)

Check that the coolant level is between the "Max" and "Min" marks on

the expansion tank.

Check that the fluid container for the windscreen washers is filled.

About every other week

Check the tyre pressure and the battery acid level.

Notes for lubricating chart

Note I

Check that the oil reaches up to the filling plug. Use all year round hypoid

oil SAE 80.

Note 2

In connection with any work in the workshop involving exposing the wheel

bearings, remove the bearings, clean them and lubricate them with high-

class durable grease in accordance with the instructions in the service man-

ual.

Subsequent adding or changing of this grease in addition to the above

is not required.

Note 3

Check that the fluid is between the "Min" and "Max" marks.

Note 4

Lubricate the felt wick under the rotor and fill a few drops of light engine oil

into the lubricating cup.

Note 5

Check the oil level when filling up with petrol. Concerning changing the oil,

see page 31.

Note 6

Have the handbrake cable lubricated with graphite grease a couple of times

a year.

Note 7

Check every 10 000 km (6 000 miles) that the oil reaches up to the filler plug.

Concerning oil change, see page 32.

Note 8

At every engine oil change check that the oil level in the centre spindle of the

carburettor(s) reaches up to about 6 mm

('/4')

from the top of the spindle.

If it does not, top up to this level. Use oil ATF type A (transmission oil).

Note 9

The oil filter should be changed every 10 000 km (6 000 miles), see page 35.

Note 10 Check the oil level every 10 000 km (6 000 miles). Concerning lubricant for a

final drive with differential brake, see page 33.