Technical data

Disassembly

11. Remove the outer flywheel housing, the flywheel

and the inner flywheel housing.

12.

Turn the engine upside down and remove the oil

pan. Be careful as the pan is glued.

NOTE! The oil pan ends also function as main bearings.

13. Remove the connecting rod bolts and remove the

connecting rods and the pistons. The connecting rod

and the connecting rod cap are marked with figures.

14. Remove the main bearing caps. The main bearing

caps are marked with a figure. The corresponding fig-

ure is punched into the block. Lift out the crankshaft.

On later engine versions an arrow is cast in the sepa-

rate main bearing caps (2002, 2003). The arrow is to

point towards the dipstick.