Specifications

2004 VOLVO XC90
the HomeLink® surface, keeping the indicator light in view. For placement questions, contact
HomeLink® toll-free 1-800-355-3515 (Internet: www.HomeLink.com).
4. Using two hands, push and hold both your hand-held transmitter's button and the transceiver button
you wish to program. The indicator light will flash first slowly, then rapidly. Rapid flashing tells you the
HomeLink® button has been successfully programmed. Release both buttons.
5. If you are programming a rolling code-equipped device (e.g., garage door opener or entry door lock),
refer to "Programming rolling codes" on the next page to complete the programming process.
Repeat steps 3 and 4 to program the other two transceiver buttons.
If, after several attempts, you are unable to successfully train the HomeLink® Universal Transceiver to
learn your hand-held transmitter's signal, contact HomeLink® toll-free 1-800-355-3515 (Internet:
www.
HomeLink.com).
pg. 181 Audio
WARNING!
- If you use HomeLink® to open a garage door or gate, be sure no one is near the gate or door while it
is in motion.
- Do not use the HomeLink® Universal Transceiver with any garage door opener that lacks safety
"stop" and "reverse" features as required by federal safety standards. (This includes any garage door
opener model manufactured before April 1, 1982). A garage door opener that cannot "detect" an
object, signalling the door to "stop" and "reverse" does not meet current federal safety standards.
Using a garage door opener without these features increases the risk of serious injury or death. For
more information on this matter, call toll-free 1-800-355-3515 (Internet: www.HomeLink.com).
NOTE: Canadian residents: During programming, your hand-held transmitter may automatically stop
transmitting. To successfully train HomeLink®, continue to hold the HomeLink® button. At the same
time, repeatedly press and hold your hand-held transmitter's button at two-second intervals until
HomeLink® has learned your transmitter's code. The HomeLink® indicator light will flash first slowly,
and then rapidly to indicate that the button has been successfully programmed.
Determining if your garage door uses a rolling code
Determine, in one of the following ways, if your garage door uses a rolling code system and is
manufactured after 1996:
● Refer to the garage door opener owner's manual for verification.
● If your hand-held transmitter appears to program the HomeLink® Universal Transceiver but the
file:///K|/ownersdocs/2004/2004_XC90/04xc90_11b.htm (9 of 11)12/30/2006 4:35:32 PM