Courtesy of: DiscountCarStereo.com Serving the internet community since 1995 A2DIY-VOL (version 10.
PRODUCT SAFETY & DISCLAIMER READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY This installation guide is provided as a GENERAL installation guide, some vehicles vary and may require additional steps. We do not accept responsibility for third party labor charges or modifications. Exercise due-diligence when installing this product.
Visor microphone Fig. 5 Fig. 6 Module Fig. 3 7. Tap YELLOW wire from installation harness to YELLOW/PURPLE (Battery supply) wire on radio harness or another source for 12V battery accessory supply (See Fig. 7) Fig. 4 Radio’s 8-pin changer port 4. 5. 6. Use clip to secure microphone to headliner or visor (See Fig. 5) Route microphone cable (10 ft. long) down side pillar, under steering column and into radio cavity, Connect microphone right angle plug to module “MIC” input. (See Fig.
Optional charging kit Fig. 10 Step drill bit 2. Fig. 8 Optional USB charger can be added to the A2DIY-HON. Should you decide to add this option, we suggest one of 3 connecting options: A. Flush to dash/panel requires drilling a ¾” hole B. Flush with Support bracket (Mount USB terminal wherever your installation demands without drilling) C.
2. Fig. 13 USB head 3. Fig. 14 Flush mounted to dash 4. Tuck and secure any extra wire from moving parts and test operation B. USB with Bracket Mount (No drilling) 1. Locate a flat surface at location of choice within 3.2 ft. of radio and mount USB support bracket (See Fig. 15) to surface using adhesive/tape or screws. Fig. 15 USB mounting bracket 4. Insert the 6 ft. USB male terminal through bracket hole (See Fig. 16) and connect to Module USB port (See Fig. 12) Fig.
Pairing module Media remote button Pairing varies among devices but basic steps are the same. This process is done upon initial install and will not have to be repeated Pairing Bluetooth remote button: Ensure Bluetooth is enabled on your 1. Turn Ignition and radio “ON” Blue LED in adapter peephole will flash (pairing mode) 2. On A2DP device: go to Settings, Wireless & Networks, Bluetooth Settings device (e.g., Smartphone/Tablet etc.) Press and hold pause/play button (See Fig.
Operation: Once paired with smartphone/Tablet, users may perform the following functions on iOS devices with Bluetooth 3.0 and later or Android 4.0 or later. Media remote functions do NOT apply to Volvo radio.
Operation: 1. 2. 3. 4. 5. 6. 7. 8. Turn ignition to ACC and radio “ON” Press radio “CD” CHG” or “CHGR” button to enter “Bluetooth” mode Launch smartphone music streaming application Use media remote to change tracks, adjust device volume, pause playback, answer/end calls etc. Place phone call or ask someone to call. Adjust call volume with media remote, steering wheel controls or radio volume knob. To end call press media remote, Pause/Play If correct operation is confirmed go ahead and reinstall radio.
