Installation Guide

PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
This installation guide is provided as a GENERAL installation guide, some vehicles vary and may
require additional steps. We do not accept responsibility for third party labor charges or
modifications. Exercise due-diligence when installing this product.
We do not accept any responsibility for vehicle damage or personal injury resulting from the
installation of this product.
Careless installation and operation can result in equipment damage.
Requirements:
Radio with cd changer controls
Introduction (newest version 10.3)
Many Volvo car owner’s adamant about keeping cars system as stock possible, will
be thrilled with the A2DIY-VOL kit which adds modern Bluetooth features without
changing the look and feel of dashboard components. Features Bluetooth Hands-
Free and music streaming from any Smartphone with A2DP and HFP support.
remote control for both Apple and Android devices allows users to track up/down,
pause, increase/decrease device volume, answer/end calls and more.
Optional Fast charging kit to keep devices fully charged while on the road.
Newest version (10.3), AUX input is no longer offered.
Support for Bluetooth 5.0 and
Call number announcement on car speakers.
Keep the radio and car you love while enjoying Bluetooth features only available
on newer cars.
For more details, see Frequently Asked question at the end of this guide.
Warning: Although not critical, we recommend disconnecting battery. Keep in
mind, most Volvo radios are coded and will not operate without code. Radio
code must be available for radio to operate upon reconnection
1. Remove radio by pressing both spring-loaded release tabs as seen in Fig. 1
Fig. 1
2. Place finger inside release ring and pull outward as seen in Fig. 2
Fig. 2
3. Connect harness 8-pin plug (See Fig. 3) to CD port (See. Fig. 4).
Factory CD changer (if present) must be disconnected.