Installation Guide

Fig. 3
Fig. 4
Radio’s 8-pin changer port
4. Use clip to secure microphone to headliner or visor (See Fig. 5)
5. Route microphone cable (10 ft. long) down side pillar, under steering column
and into radio cavity,
6. Connect microphone right angle plug to module “MIC” input. (See Fig. 6)
Wind noise will negatively affect phone audio. Users are advised to install
microphone away from wind/ventilation ducts etc.
Visor microphone
Fig. 5
Fig. 6
Module
7. Tap YELLOW wire from installation harness to YELLOW/PURPLE (Battery
supply) wire on radio harness or another source for 12V battery
accessory supply (See Fig. 7)
Fig. 7
11. Secure module and proceed to next section.