Installation Guide

Optional charging kit
Fig. 8
Optional USB charger can be added to the A2DIY-HON. Should you decide to add this
option, we suggest one of 3 connecting options:
A. Flush to dash/panel requires drilling a ¾” hole
B. Flush with Support bracket (Mount USB terminal wherever your installation
demands without drilling)
C. USB port- (default)
Features:
» Input voltage: 6-24V DC
» Working current: 30mA
» Default output voltage: 5V or 3V-12V (if device supports it)
» Max output power: 24W
Should you decide to add the USB Port, we suggest 2 mounting options:
A. Flush to dash/panel requires drilling a ¾” hole in the dash
B. Flush with Support bracket (use this option to mount USB terminal wherever
your installation demands without drilling)
A. Flush to Dash or Panel (requires drilling)
1. Drill a ¾” hole in the dash or panel using a step drill bit or equivalent (See
Fig. 10)
Fig. 10
Step drill bit
2. Insert USB male terminal through the ¾” hole created in step 1 and
connect to module USB port (See Fig. 12)
Fig. 11
USB 6 ft. cable with bracket
Fig. 12
USB charging port
3. Push USB head (See Fig. 13) until it snaps in place and flush with mounting
surface (See Fig. 14)