Installation Guide

Fig. 13
USB head
Fig. 14
Flush mounted to dash
4. Tuck and secure any extra wire from moving parts and test operation
B. USB with Bracket Mount (No drilling)
1. Locate a flat surface at location of choice within 3.2 ft. of radio and mount
USB support bracket (See Fig. 15) to surface using adhesive/tape or
screws.
Fig. 15
USB mounting bracket
2. Insert the 6 ft. USB male terminal through bracket hole (See Fig. 16) and
connect to Module USB port (See Fig. 12)
Fig. 16
3. Push USB head until it snaps in place and flush (See Fig. 17)
Fig. 17
4. Connect BLACK wire to ground (radio chassis or harness ground wire), and
RED or YELLOW to accessory or battery supply. Your choice!
Accessory connection: charging is possible with ignition/engine “ON”.
Battery connection: charging is possible at all times.
Tuck away any extra wires and verify BLUE LED is lit.