Operation Manual

02 Instruments and controls
HomeLink


*
02
84
* Option/accessory, for more information, see Introduction.
3.
Depress the HomeLink

button being
programmed, hold it depressed for
5 seconds and then release it. Repeat if
necessary until the garage door is acti-
vated. If the door is not activated, press the
programmed HomeLink

button and hold
it depressed and check the indicator lamp.
>
Constant glow: The indicator lamp illu-
minates with a constant glow when the
button is kept depressed, this indicates
that the programming is complete.
The garage door, gate or similar should
now be activated when the pro-
grammed HomeLink

button is
depressed.
Glow not constant: The indicator lamp
flashes quickly for approx. 2 seconds
and then changes over to a constant
glow. In which case, continue with the
programming steps 4-6 in order to com-
plete the programming of a device with
rolling code (usually a garage door
opener).
4.
Locate the "programming button
2
" on the
receiver for the garage door for example,
normally located close to the antenna's
bracket on the receiver.
5. Depress and release the receiver's "pro-
gramming button". The button flashes for
approx. 30 seconds and the next step must
be carried out within this period.
6. While the receiver's "programming button"
is still flashing, press the button on
HomeLink

being programmed and hold it
depressed for approx. 2 seconds and then
release it. Repeat the press/hold/release
sequence up to 3 times to conclude the
programming.
Operation
When HomeLink

is fully programmed it can be
used in place of the separate original remote
controls.
Press the programmed button and hold it
depressed until the garage door, alarm system,
etc. is activated (may take several seconds).
Naturally the original remote controls can still
be used in parallel with HomeLink

if required.
NOTE
If the ignition is switched off, HomeLink

will
work for 30 minutes after the driver's door
has been opened.
If programming problems persist, contact
HomeLink

on: www.homelink.com or ring
00 8000 466 354 65 (or premium rate phone
number [phone]).
Resetting the HomeLink

buttons
It is only possible to reset all of the
HomeLink

buttons at the same time, not each
button individually. However, individual but-
tons can be reprogrammed, see the following
section "Programming individual buttons".
1. Depress the two outer buttons on
HomeLink

and do not release until the
indicator lamp starts to flash.
2. Release the buttons.
>
HomeLink

is now set in so-called
"learn mode" and is ready to be reprog-
rammed, see section "Programming
HomeLink®" on page 83.
2
Button designation and colour vary depending on manufacturer.