Operator`s manual

INSTRUMENTS AND CONTROLS
121
Mist and Ice Removal
DO NOT attempt to drive with the windshield
covered by mist, or fog or frost. The visibility is
reduced, which could lead to an accident causing
severe personal injury or death.
1. Turn knob to defrost.
2. Rotate the temperature knob to add heat as necessary.
3. Set the fan speed knob to maximum (the extreme right).
Use these instructions to keep the windshield clear at all times.
Maximum heat output for fast defrosting can only happen after the
engine has reached operating temperature.
While driving in extreme cold, adding heat to the windshield may
change drifting snow to ice, in this case, setting the air distribution to
floor and/or panel only may allow the drifting snow to be brushed off
by the windshield wiper.
Clean the inside of the window using normal window cleaner in order to
minimize the risk of misting. Clean more often if a passenger smokes in
the cab.
vn-vhd.bk Page 121 Tuesday, July 1, 2008 9:44 AM